satex
10-13-2011, 11:04 PM
My previous approaches get me close but lack the level of detail around the edges that I am looking for.
Best approach (was close but no cigar): Create plane with many segments, add material with image of leaf, position near tube and knife out an outline of the leaf on the tube. This result yielded very jagged unatural edges.
End game: Export as *.stl for 3d printing. Which limits me basic modeling.
Any ideas would be greatly appreciated.
Regards,
Satex
Best approach (was close but no cigar): Create plane with many segments, add material with image of leaf, position near tube and knife out an outline of the leaf on the tube. This result yielded very jagged unatural edges.
End game: Export as *.stl for 3d printing. Which limits me basic modeling.
Any ideas would be greatly appreciated.
Regards,
Satex