kwaiet
01-03-2011, 10:04 PM
Hi,
I am new to this forum and new to RF. I was wondering if anyone knows how to setup or how to run an RF simulation using the no gui.
I have a Hybrido sim, I have done the waves. But the computer bogs down when trying to do the splash.
I looked at my activity monitor and see that it is only using 1 out of 8 cores. I know that the gui version runs in 32 bit.
But when I switched the file over to the PC side, it was also running on only 1 core. I read the RF site and it is a 64-bit app, so I was wondering why it only uses 1 core.
MY QUESTION IS:
Is it possible to have the wave sim cached and then run a no gui sim on the splash??
Will RF write out the cache files for that??
How do you run a sim on "no-gui" mode?
How do you start RF in "no-gui" mode?
If anyone can help, that would be much appreciated.
Thanks DT, you guys are awesome!!
I am new to this forum and new to RF. I was wondering if anyone knows how to setup or how to run an RF simulation using the no gui.
I have a Hybrido sim, I have done the waves. But the computer bogs down when trying to do the splash.
I looked at my activity monitor and see that it is only using 1 out of 8 cores. I know that the gui version runs in 32 bit.
But when I switched the file over to the PC side, it was also running on only 1 core. I read the RF site and it is a 64-bit app, so I was wondering why it only uses 1 core.
MY QUESTION IS:
Is it possible to have the wave sim cached and then run a no gui sim on the splash??
Will RF write out the cache files for that??
How do you run a sim on "no-gui" mode?
How do you start RF in "no-gui" mode?
If anyone can help, that would be much appreciated.
Thanks DT, you guys are awesome!!