Extruding

[oldhippie_tom]

Good morning. I have a question about extruding. I do some car modeling and wish I could figure how to extrude a shape that will be the rubber molding that goes around the windows. Is it possible to get my shape for the molding to extrude along the outside edges of my planes that are the window. It will have more than one edge as the window is more than one plane. I hope this makes sense. I think I could use a EP Curve to make a shape to extrude along, but that may be hard to get to line up nice with the edges of the window.

Thanks!!

[brandeil]

If u use 4 edges u should be able to with multi rail.

[oldhippie_tom]

If u use 4 edges u should be able to with multi rail.

Well, if I duplicate it (windshield) and in the duplicate delete all of the edges and make it one plane and then extrude around those outside 4 edges using multi rail and it should fit on the original. I will check into mullti rail as I have not used that.

Thank you for your suggestion!!!!