DigiTut_name
09-14-2006, 08:21 PM
Ok, I'm at the part where you create the path for the animation, part07 on disk4. When I apply the Set Path command, set all my key frames and run the animation I can see that the linked parameters that were set up earlier in part02 get messed up. The thruster rotates as it's supposed to while going around the curve but after it comes out of the curve it doesn't rotate back to where it's supposed to be when the bike is totally upright. After that it will just stay in that position (the one it's in while going around the curve) permanently.
I somehow managed to get the thrusters to reset themselves and work correctly again by deleting the path constraint but as soon as I applied Set Path again it did the same thing. If someone can tell me how to fix this I would be grateful.
I somehow managed to get the thrusters to reset themselves and work correctly again by deleting the path constraint but as soon as I applied Set Path again it did the same thing. If someone can tell me how to fix this I would be grateful.