New to maya

[dwright]

Help I'm new to maya and have what may be a silly question.
When using image planes as a reference, after you have traced curves in side, front views, the curves are flat on those planes. what do you do to get a 3D model out of these curves.

Any reply will greatly be appreciated. Thanks!

[brandeil]

have u looke at the free videos??
In the properties menu u can move the planes off center so they are not in the way.
:)

[papa]

You might want to check out our Maya Basics second edition which will get you up to speed faster than trying to figure it out on your own.

Papa

[Hard_Drive]

im sure there are many ways as im a little new but i have some knowledge.
one way is to loft. and i suggest the maya basics second edition as papa said.
those cd's helped me so much i cant even describe it. its not even that expensive.